
AAIB initial probe needs to be taken into global quorum to ensure 787 aircraft safety
Thrust Setting is manual (not autopilot/AUTO THROTTLE) and MAX TAKE OFF THRUST; and focus, attention is on continuing flight and flight controls, never on the throttle quadrant, since thrust is set to MAX TAKE OFF THRUST.
From the AI 171 preliminary report, which will have a global ramification on all 787 operators, it is reported that the fuel valves/switches were moved to CUT OFF.
It is highly unlikely that any pilot, especially during takeoff would want to meddle or fiddle around with switches behind the thrust levels. At best, you would focus on raising the landing gear which is located in the front panel of the cockpit, or raise the flaps.
The reason why the Fuel Valves/Switch was turned back to CUTOFF is something that needs to be investigated.
It must be noted that the 787 has a cockpit camera and all pilot and co-pilot actions would have been recorded. Strangely, and shockingly, the Preliminary Report does not mention reference to the Cockpit Camera Recording and Footage.
The NTSB, the FAA, EASA in addition to the AAIB need to investigate to the fullest as to why did the 'Fuel Switch to Cut Off'. No pilot would be stupid to cut fuel to both engines during a phase when he needs engine power the most.
It is imperative that we wait for the entire, comprehensive investigation report to come out. If the Fuel Cut Off switches moved automatically to cut off, so as the AI 171 initial report says, then airlines that operate the 787 today need to review and investigate potential Fuel Switch Runaway with their aircraft.
The 787 Dreamliner is a comprehensively digitally controlled and software-driven aircraft which constantly needs patch and systems updates. If the Fuel Switches moved to CUTOFF, the cause of this trigger needs to be established.
Furthermore, to this I may add that no pilot is stupid, or inept to want to play around with switches in the middle section of cockpit when all attention is focused on forward flight cockpit instruments located in front of the pilots, during takeoff and landing.
This will be a complex crash to investigate for the NTSB, AAIB, Boeing, EASA, the Indian DGCA and the UKCAA, and no stone should be left unturned with this investigation.
It is imperative that this investigation also be taken into the global quorum, with the including of ICAO, CAA Canada and other safety oversight regulators, that manage and oversee the 787 aircraft operation in their jurisdiction.

Try Our AI Features
Explore what Daily8 AI can do for you:
Comments
No comments yet...
Related Articles


NDTV
21 minutes ago
- NDTV
Kinetic DX Electric Scooter Teaser Out Ahead Of July 28 Launch
Kinetic Green is set to launch a new electric scooter in the Indian market on July 28. Named after the DX, the electric two-wheeler is billed as the modern version of the two-stroke Kinetic Honda DX, which was available in the Indian market over 40 years ago. After the announcement of its launch, the brand has released the first teaser of the EV. Once launched, it will be a rival to models like the Bajaj Chetak, TVS iQube, Hero Vida VX2, Ather Rizta, and others. Starting with the design details, the electric scooter is expected to have illuminated logos. One of these units with the Kinetic lettering will be placed above the horizontal headlamp, with the logo on the front apron highlighted by the black panel. The teaser also provides a glimpse of the electric scooter's switchgear. This hints that the EV will have fake exhaust noises, probably imitating the original model. Images captured during testing of the electric scooter have provided a clearer view of the vehicle, showcasing its simple design that strongly resembles the original DX. Kinetic has shared some minor specifications about the scooter, such as the inclusion of a TFT display. The company has also announced that the battery choices for the scooter will vary between 1.8 kWh and 3 kWh, with a maximum speed of 80 km/h. From a mechanical perspective, the spy shots have indicated that the scooter will come equipped with a front disc brake and a hub-mounted electric motor, while the suspension will consist of a telescopic fork in the front and dual shocks in the rear.


Mint
an hour ago
- Mint
In charts: Thousands of Indian auto workers are losing fingers to unsafe factories
More than 4,000 workers have reported injuries in Indian automotive supply chains since 2019, with around 80% these being loss of fingers, according to an annual report by Safe In India (SII) Foundation. The report, titled Crushed, covered 7,500 auto workers in Maharashtra and Haryana who have suffered non-fatal injuries since 2019 and sought SII's help to get benefits under the Employees' State Insurance Corporation (ESIC) benefits. ESIC is a government social security and health insurance scheme for registered workers, designed to protect them and their dependants from financial distress because of sickness, disability, maternity break, or death at work. SII's growing database aims to plug the data gap that exists over accidents and injuries in the industrial sector, but it is not a national-level dataset and does not reflect the pan-India trend. 'Crushed reports have covered Haryana since 2019 and Maharashtra since 2022, based on when our worker assistance centres were established there," said VN Saroja, head of worker safety at SII. Crushed injuries The latest edition of the survey said there were at least 875 injuries in automobile supply chains in 2024, and 69.7% of these were 'crushed injuries' (lost fingers). Crushed injuries have surpassed other types of injuries, though their share in overall non-fatal injuries documented by SII fell from 85.3% in 2019 to 69.7% last year, it said. Both Haryana and Maharashtra fared equally poorly on crush injuries. In Maharashtra, 80% of auto workers lost a body part at the workplace between 2022 and 2024, and 78% suffered a similar fate in Haryana from 2019 to 2024. The latest government data from the Directorate General Factory Advice Service and Labour Institutes shows there were 56.9 fatal injuries per million workers and 154 non-fatal injuries per million workers in 2023. Industry-wise data is not available. The reported said the typical injured worker is a migrant youth with a level of education. About 60% of injured workers assisted by SII had left their studies between Class V and X. In contrast, only 4% of injured workers had a graduate degree or diploma. About 87% of injured workers in Haryana were migrants, and 62% in Maharashtra. Disregard for safety Power press machines and the lack of proper safety equipment for workers are the primarily reasons for crushed injuries, the report said. Power press machines, 78% of crushed injuries last year, also cause more serious injury than other machines in auto factories, it said. Power presses are machines used to cut and give shape to metal sheets. 'Crushed injury in power press machines is more severe as it results in a greater number of finger losses in case of accident/malfunction," the report said. A lack of safety gear compounds the problem, SII said. More than 70% of the workers it said they were not given protective gear such as safety tongs, earplugs and protection Economic Survey 2024-25 had also highlighted the issue, noting India's manufacturing (11.4% of the total workforce) and construction (12%) workers were prone to workplace accidents.


Time of India
2 hours ago
- Time of India
Honda eyes 30% share in Indian two-wheeler market, sees potential to grow sales among women
Japanese auto major Honda is targeting a 30 per cent share in the Indian two-wheeler market by 2030, as it chases the goal to achieve half of global two-wheeler sales in the long term, according to a top official of the company's arm in India. The company's arm, Honda Motorcycle & Scooter India (HMSI), sees huge potential to grow sales among female customers, who currently account for just about 10 % of the overall industry sales, HMSI President Tsutsumu Otani told PTI in an interview. He also said that while the company sees a shift from internal combustion engine ( ICE ) to electric vehicles in the two-wheeler segment in the long term, bottlenecks around charging infrastructure and electricity supplies are major impediments at present. "Considering the Indian market size, we want to achieve 30 per cent share in India by 2030," Otani said when asked about the significance of the Indian market in Honda's overall long-term goal to garner 50 per cent of global two-wheeler sales. Currently, he said HMSI has a 27 per cent market share in the Indian market. Otani said that already in the ASEAN region, Honda has over 80 per cent market share. Earlier in January this year, Honda Motor Co announced that the industry-wide global motorcycle (two-wheeler) sales, currently at a scale of 50 million units, are projected to grow to 60 million units by 2030, including electric vehicles. The company has set "a long-term target" for itself to capture a 50 per cent share of the global motorcycle market, including electric motorcycles. According to the Federation of Automobile Dealers Associations (FADA), the total two-wheeler retail sales in India stood at 1,88,77,812 units in FY25 compared to 1,75,27,115 units in FY24. HMSI's retail sales in FY25 were 47,89,283 units against 40,93,895 units in FY24. It was the number two player after Hero MotoCorp, which clocked 54,45,251 units in FY25 and 53,97,315 units in FY24. Otani noted that Honda sees huge potential to tap female customers to increase its two-wheeler sales in India with increasing women empowerment and many of them entering the workforce. "In India, the overall two-wheeler usage is mostly male, with 90 %, and females just around 10 per cent. It means the potential for two-wheeler sales to grow among the female customers is huge," he said. When asked about the company's product pipeline programme for the Indian market to achieve the 2030 target, Otani declined to comment, but asserted that, being a global company, Honda has a range of products in its portfolio, which can be considered for India. Otani said the company will consider a wide range of technologies, including EVs and flex fuels, for the Indian market, considering the different consumer demands in different parts of the country. Honda had stated that it plans to introduce 30 electric models globally by 2030 to achieve the goal of increasing its global annual sales of electric motorcycle models to 4 million units by 2030. The company had also said it would strive to capture the largest market share in the electric two-wheeler segment in India, where it will begin operating a dedicated electric two-wheeler production plant in 2028. When asked if the company has finalised the location of the EV-only plant and investments for it, Otani said it has not been decided as yet. He said in the long term, the shift from ICE to electric vehicles will happen in India, but at present, the bottlenecks around charging infrastructure and electricity supplies are major impediments.